Tabs

Sample Tab Configuration dialog box

1. Click to open Tab Configuration dialog box.
2. Click Add tab to add a new tab.
3. For each tab configure the following properties:
   1. Name — The Tab name property specifies the label for the tab in the Tab control.
   2. Screen path —

      The Screen path property specifies the screen that will open in the body of the Tab control. Browse for the screen file. The Nested View is only available if a screen is configured for the tab. If no screen is specified, the Nested View does not display in run mode.

      Click to select a path and file from the Open / Open File / Select File dialog box, where you can access:

      • BSS — Indicates that the file is stored in an APPS or BSS folder
      • Local — Indicates that the file is stored in a local or network file-system folder.

      Note: This control only supports Canvas screens in CygNet v9.4 and later. It does not support the display of CygNet Studio screens (.csf).

4. Tabs can be easily reordered by dragging and dropping a tab a new location in the list.
5. Or click (Delete tab) to remove a selected tab as necessary.
6. Once the tabs are configured, click OK to save.
7. Or click Cancel to abort and close the Tab Configuration dialog box.